ThermRite™ PRO 16mm UFH Panel – Dual Purpose EPS400 Board with 200 Micron Foil for Tile or Wood Floors

One Panel. All Purposes. The ThermRite™ PRO 16mm Panel is a premium dual-purpose underfloor heating board, specially engineered for maximum flexibility, superior strength, and high heat output in a low-profile system.

At just 16mm thickness, it’s perfect for installing over existing screed or timber floors, and it’s ready to handle any floor finish—from tile and vinyl to wood and laminate. Whether you're planning floating floors or bonded finishes, ThermRite™ PRO adapts effortlessly.

Built from EPS400 insulation (400 kPa compressive strength) and finished with a 200-micron aluminium foil layer, it delivers fast, even heat distribution and long-lasting durability—covered by a 50-year guarantee.

Installation Made Easy

• For floating wood/laminate floors: Lay panels over the subfloor and float interlocking boards at 90° to pipe direction.
• For tile/vinyl finishes: Bond panels to floor with EPS Contact Spray Adhesive or flexible tile adhesive, install pipe, and apply a 5–10mm self-levelling compound before tiling or finishing.

No clips needed—the grooved design securely retains 12mm multilayer pipe at 150mm centres, delivering higher heat output than wider-spaced systems.

Key Features:

• Low Profile – Only 16mm Thick
• High Heat Output with 150mm Pipe Spacing
• EPS400 – 400 kPa Compressive Strength
• Dual Purpose: Use with Tile, Vinyl, Laminate or Wood
• 200 Micron Foil Layer for Fast, Even Heat Transfer
• Secure Pipe Retention – No Extra Fixings Required
• Panel Size: 1200mm x 600mm (0.72m² each)
• Pack Size: 14 Panels = 10.0m² Coverage
• 50-Year Product Guarantee
• Minimum Order: 10 Panels

Click for: Product Installation & Data Sheet

Frequently Asked Questions

• What makes this panel “dual purpose”?

It’s suitable for both floating floors (wood/laminate) and bonded finishes (tile/vinyl), using different installation methods.

• What pipe size and spacing does it support?

The panel is grooved for 12mm multilayer pipe, spaced at 150mm centres for increased heat output.

• Do I need to screed over it?

Only if you’re using tile, vinyl, or bonded wood/carpet finishes. Use a 5mm leveller for tile or 10mm for vinyl.

• How do I secure the panels to the floor?

Use EPS Contact Spray Adhesive or Rapid Set Tile Adhesive to bond the panels to a solid screed or 18mm plywood deck.

• Can this be used in a retrofit project?

Absolutely. It’s perfect for low-profile retrofits over existing floors where minimal build-up height is required.